Disassembly and Assemb&
3.2.2 Electrical Component Removal
(MCU PWB), high voltage supply board (l-lVPS), low voltage supply unit (LVPS), earth plate, and
fan unit.
3.2.2.1 ELEC Cover Removal
1. Remove the rear cover. (Refer to%ction32.1.l.)
Remove the top cover. (Refer to Section 3.2.l.2.)
2.
3. Remove theleftcover. (Refer to Section 3.2.13.)
4. Remove the right cover. (Refer to Section 3.2.l.4.)
5. Remove 18 CB screws (M3 x 6) securing the shield cover, and remove it.
6.
7.
Remove 8 CB screws (M3 x 6) and 2 CBB screws (l@ x 8) securing the ET-EC cover, and
remove it.
3-6
Figure
Removing the Shield Cover
3-5.
Figure 3-6. Removing the ELEC Cover
MAIN bead, mgine controller board
.>..
Rev. A