Front Cover Removal - Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer Service Manual

Disassembly and Assembly

Front Cover Removal

3.2.4.5
1. Remove the MSI tray. (Refer to Section 324.13.)
Remove the rear cover. (Refer to Section 3.2.1.1.)
2.
Remove the top cover. (Retkr to Section 3.2.1.2.)
3.
Remove the left cover. (Refix to Sedon 3.2.1.3.)
4.
Remove the right cover. (Refer to Section 3.2.1.4.)
5.
Remove the ELEC cover. (Refer to Section 3.2.2.1.)
6.
Remove the link assembly. (Refer to Section 3.2.4.1.)
7.
Disconnect connector P/J16 from the MCU PWB board.
8.
9.
10.
11.
Remove 1 CBB screw (M3
Figure 3-27. Removing the Front Cover (1)
12.
Remove 2 CBB screws (M3
Remove the retard pad from front cover.
13.
Figure 3-28. Removing the Front Cover (2)
3-18
6) securing the earth wire to the front frame.
x
6) securing the front cover, and remove it.
x
Rev. A