McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Manual page 280

FC Management MIB
B
connUnitPortName
E/OS SNMP Support Manual
B-32
offlineConnUnitPort:
onlineConnUnitPort:
resetConnUnitPortCounters: If the addressed connUnit allows this
NOTE: Each implementation may chose not to allow any or all of these
values on a SET. On a read, if you do not support write, then return invalid.
Otherwise return the last control operation attempted.
Sequence
::= { connUnitPortEntry 16 }
DisplayString
Syntax
read-write
Access
mandatory
Status
A user-defined name for this port. This means that up to
Description
DisplayString characters may be supported. If less than, then the
name will be truncated in the connunit.
If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'offline' operation.
Examples of these operations are
disabling a port's transceiver, the Link
Failure protocol, request
(NON-PARTICIPATING) command to
the Loop Port state machine, or removal
of the port from an arbitrated loop by a
hub.
If the addressed connUnit allows this
operation to be performed to this port,
the addressed port performs a
vendor-specific 'online' operation.
Examples of these operations are
enabling a port's transceiver, the Link
Failure protocol, request
(PARTICIPATING) command to the
Loop Port state machine, or addition of
the port from an arbitrated loop by a
hub.
operation to be performed to this port,
the addressed port statistics table
counters will be set to zero.