Configuring Ieee 802.1X; Installing A Site Certificate; Installing Device Certificate - Ricoh Aficio SP 5210DN Hardware Manual

5. Configuration

Configuring IEEE 802.1X

IEEE 802.1X can be configured using Web Image Monitor's administrator mode. You can select four types
of EAP authentication method: EAP-TLS, LEAP, EAP-TTLS and PEAP. Note that each EAP authentication
method has different configuration settings and authentication procedures.
Types and requirements of certificates are as follows:
EAP Types Requiring a "Site Certificate"
EAP-TLS, EAP-TTLS, PEAP (Necessary except LEAP)
EAP Types Requiring a "Site Certificate" and a "Device Certificate"
EAP-TLS, PEAP (Phase 2 is for TLS only)
If a certificate is required, configure all settings after installing the certificate.
5

Installing a Site Certificate

Access the authentication server and obtain the CA certificate.
Methods of obtaining certificates differ according to the operating system you are using.
1. Log in to Web Image Monitor as an administrator.
2. In the menu area, click [Configuration].
3. Under "Security", click [Site Certificate].
4. Click [Browse] on the "Site Certificate to Import" window, and then select the CA certificate
you obtained.
5. Click [Import].
6. Check that the imported certificate's [Status] shows "Trustworthy".
If [Site Certificate Check] shows [Active], and the [Status] of the certificate shows [Untrustworthy],
communication might not be possible.
7. Click [OK].
8. Click [Logout].
9. Quit the Web Image Monitor.

Installing Device Certificate

1. Log in to Web Image Monitor as an administrator.
2. In the menu area, click [Configuration].
3. Under "Security", click [Device Certificate].
4. Click [Certificate 2] on the "Device Certificate" window, and then click [Request].
94