Installing The Wireless Lan Interface Board - Ricoh Aficio SP 5210DN Hardware Manual

Connect the cable to the Gigabit Ethernet board. For details see p.69 "Ethernet Cable
Connection" or p.72 "USB Cable Connection".
• Confirm that the Gigabit Ethernet board was correctly installed by printing the configuration page. If
it is correctly installed, "Gigabit Ethernet" will appear for "Device Connection" on the configuration
page.
• If the board was not installed properly, repeat the procedure from step 4. If it cannot be installed
correctly even after reattempting installation, contact your sales or service representative.
• For details about printing the configuration page, see p.44 "Test Printing".
• Before using the Gigabit Ethernet board, you must configure settings from the printer control panel.
For details, see p.75 "Ethernet Configuration".

Installing the Wireless LAN Interface Board

• Before beginning work, ground yourself by touching something metal to discharge any static
electricity. Static electricity can damage the unit.
• Do not subject the unit to physical shocks.
CEC059
Installing the Interface Units
3
61