Inspecting Router Components And Accessories - Juniper E120 - RELEASE 11.1.X HARDWARE GUIDE 3-25-2010 Hardware Manual

E120 and E320 11.1.x Hardware Guide
To unpack the router:
1.
2.
3.
4.
Figure 9: Removing an L-bracket

Inspecting Router Components and Accessories

After you remove the equipment from the shipping containers:
20
Inspecting Router Components and Accessories
Cut the two straps that secure the carton to the skid, open the carton from the
top, and remove the box of accessories that sits on top of the router.
Unlock the four plastic clips that hold the box to the skid by squeezing them in
their center and pulling out, and then lift the carton off the router.
Remove the three screws that attach each of the two L-brackets to the router.
To avoid scratching the router when removing it from the skid, detach one of
the L-brackets from the skid by removing the three screws. See Figure 9 on
page 20.
Confirm the contents of each container.
Inspect all external surfaces and external connectors for visible signs of damage.
Inspect all accessories shipped with each unit.
Document any damage noted during your inspection.
Confirm that the router has the correct number and type of modules for your
ordered configuration.