Removing Sfps - Juniper E120 - RELEASE 11.1.X HARDWARE GUIDE 3-25-2010 Hardware Manual

Figure 23: Installing an SFP on an IOA
4.
5.
6.
7.

Removing SFPs

To remove an SFP:
1.
2.
3.
4.
Slide the SFP as far as you can into the IOA until the SFP clicks into place.
If the SFP does not slide smoothly into the IOA, make sure that the orientation
of the SFP is correct.
Gently pull the SFP to confirm that it is inserted correctly.
If the SFP comes out of the slot when you pull it, repeat Step 4.
Remove the dust cover that protects the cable connectors.
Connect the new cables to the SFP.
Obtain an antistatic container for the SFP you plan to remove. (See "Storing
Modules and Components" on page 69.)
Ground yourself by using an antistatic wrist strap or other device and connect
it to an ESD grounding jack.
Disconnect the cable from the SFP on the IOA.
Identify the release mechanism for the SFP.
Different SFPs use different release mechanisms. See Figure 24 on page 46 for
possible release mechanisms, which include:
A button that you press inward
A ring that you press inward
Chapter 4: Installing Modules
Installing and Removing SFPs
45