The Next Step - Juniper E120 - RELEASE 11.1.X HARDWARE GUIDE 3-25-2010 Hardware Manual

E120 and E320 11.1.x Hardware Guide
Figure 24: Possible Release Mechanisms on the SFP
5.
6.
When you have replaced the SFPs and connected the cables, issue the appropriate
show interface command for each interface to verify that the interface is operational
(up).

The Next Step

After you install the modules, you can connect cables to the system. See "Cabling
the Router" on page 47.
46
The Next Step
A bar that you pull sideways, then outward
A tab that you pull sideways, then outward
Release the SFP and pull it out of the slot.
Place the SFP in an antistatic bag.