ERX 11.3.x Module Guide
SRP-10G Module Combination (2-GB Memory)
Line module label
I/O module label
Number of I/O ports
Software release
Description
Type
Capability
Software features
Model compatibility
SRP module compatibility
Module redundancy support
Cables and connectors
LEDs
Alarms, errors, and events
82
SRP-10G
SRP I/O
7
First supported: 4.1.3 or later 4.1.x release, 5.0.4 or later 5.0.x release, 5.1.2
or higher-numbered release, 5.2.0
Final supported: Not applicable
125 W
Switch route processor (10 Gbps)
Has a minimum of 2 GB of error checking and correction (ECC) memory with
a 1-GB nonvolatile storage (NVS) card.
The 512–MB version has reached end-of-life.
Not applicable
Ethernet (IEEE 802.3)
10/100Base-T
RS-232
Not applicable
ERX710 Router
ERX1410 Router
SRP-10G
1:1 redundancy
Terminal blocks
BNC, 75–ohm
Wire wrap posts
RJ-45
RS-232 (DB-9)
See ERX Hardware Guide, Chapter 5, Cabling ERX Routers for more
information.
See "Module LEDs" on page 109.
See Monitoring Modules in JunosE System Basics Configuration Guide,
Chapter 6, Managing Modules.
Copyright © 2010, Juniper Networks, Inc.