Clean Up From Testing - Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual

42 Click each tab to verify that you can access them.
43 Close Sentinel Data Manager.
If you were able to proceed through all of these steps without errors, you have completed a basic
verification of the Sentinel system installation.

4.2 Clean Up from Testing

After completing the system verification, you should remove the objects that were created for the
tests.
To perform a clean up after system testing:
1 Log in to the system as an admin user (esecadm by default).
2 Click the Correlation tab.
3 Open Correlation Engine Manager.
4 Right-click
TestRule1
5 Open Correlation Rule Manager.
6 Select
and click Delete.
TestRule1
7 Click the Event Source Management menu, and select Live View.
8 In the Graphical event source hierarchy, right-click General Collector and select Stop.
in the Correlation Engine Manager and select Undeploy.
Testing the Installation 79