Configuring Sentinel Control Center To Integrate With Crystal Reports Server - Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual

8.7 Configuring Sentinel Control Center to
Integrate with Crystal Reports Server
The Sentinel Control Center can be configured to integrate with the Crystal Reports Server, allowing
you to view Crystal Reports from within Sentinel Control Center.
To enable Sentinel Control Center integration with Crystal Reports Server, follow the instructions
below.
NOTE: This configuration must be performed only after the Crystal Reports Server has been
installed and Crystal Reports have been published to it. For more information on supported
platforms for Crystal Reports Server in a Sentinel environment,
on page 17.
To Configure Sentinel to Integrate with Crystal Reports Server:
1 Log into Sentinel Control Center as a user that has privileges to the Admin tab.
2 On the Admin tab, select Crystal Report Configuration.
3 In the Analysis URL field, provide the following:
http://<hostname_or_IP_of_web_server>:<web_server_port_default_8080>/
esec-script/
GetReports.jsp?APS=<hostname>&user=Guest&password=&tab=Analysis
NOTE: <hostname_or_IP_of_web_server> must be replaced with the IP address or hostname
of the Crystal Reports Server.
NOTE: The URL above will not work properly if the APS is set to the IP Address. It must be
the host name.
NOTE: <web_server_port_default_8080> must be replaced with the port the Crystal Web
Server is listening on.
4 Click Refresh next to the Analysis URL field.
5 If you have Advisor installed, provide the following in the Advisor URL field:
http://<hostname_or_IP_of_web_server>:<web_server_port_default_8080>/
esec-script/
GetReports.jsp?APS=<hostname>&user=Guest&password=&tab=Advisor
NOTE:
hostname of the Crystal Reports Server.
NOTE: The URL above will not work properly if the APS is set to the IP Address. It must be
the host name.
NOTE:
Server is listening on.
6 Click Refresh next to the Advisor URL field;
Click Save.
138 Sentinel 6.1 Installation Guide
<hostname_or_IP_of_web_server>
<web_server_port_default_8080>
Chapter 2, "System Requirements,"
must be replaced with the IP address or
must be replaced with the port the Crystal Web