Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual page 46

13 If you select only Collector Manager and do not select Data Access Server (DAS), select the
option for establishing communication between the Sentinel Collector Managers and the
Sentinel Server. You can select Connect to message bus directly or Connect to message bus
using proxy.
For more information on these two options, see
on page
If you select Connect to message bus using proxy, immediately after the installation is complete
you are prompted for the information that is required to register this Collector Manager as a
trusted client. Before you select this option, ensure that the Communication Server is running.
If the Communication Server is not available, first select Connect to message bus directly and
later manually configure the Proxy type communication by performing
14 Specify the Communication Server port or host server name information.
The port numbers must be identical on every machine in the Sentinel system to enable
communications. For more information on the port numbers used for Sentinel 6.1, see
Section 3.3, "Port Numbers Used for Sentinel 6.1," on page
future installations on other systems.
15 Click Next.
46 Sentinel 6.1 Installation Guide
91.
Chapter 6, "Communication Layer (iSCALE),"
Step 5 on page
31. Make a note of these ports for
52.