Collector Manager - Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual

5 If you select Accept, this message displays every time you try to open Sentinel on your system.
To avoid this, you can select Accept permanently.
To Start the Sentinel Control Center on Linux and Solaris:
1 As the Sentinel Administrator User (esecadm), change directory to:
$ESEC_HOME/bin
2 Run the following command:
control_center.sh
3 Provide your username and password and click OK.
4 A Certificate window displays, click Accept.
The Sentinel Control Center users will need to repeat the procedure above to accept a new certificate
under these circumstances:
The Sentinel communication server is reinstalled

The Sentinel communication server is moved to a new server


6.1.2 Collector Manager

Collector Manager can be installed in either proxy mode (using the SSL proxy) or direct mode
(connecting directly to the message bus).
For Collector Managers that could be more easily compromised (for example, a machine in the

DMZ), the SSL proxy is the more secure method of communication.
For Collector Managers in a more secure environment or where high event throughput is

important or installed on the same machine as the Data Access Service (DAS), direct
communication to the message bus is recommended.
The Collector Manager connects to SSL through the
Collector Manager to restart without human intervention after a reboot, this port is set up to use both
server and client SSL certificate authentication. A trust relationship is established between the proxy
and Collector Manager (certificate exchange), with future connections using the certificates to
authenticate. This trust relationship is set up automatically during installation.
proxied_trusted_client
Communication Layer (iSCALE)
. To enable
93