Completing The Installation - Novell SENTINEL 6.1 SP2 - INSTALLATION GUIDE 02-2010 Installation Manual

 Redo Log Member A Directory
Redo Log Member B Directory

13 Click Next.
IMPORTANT: For recovery and performance purposes, Novell recommends that these
locations be on different I/O devices.
For performance reasons, the Redo Log should point to the fastest write disk you have
available.
The installer does not create these directories, so they must be created externally before
continuing beyond this step, and they must be writable by the oracle user. For more
information, see Section 3.4.2, "Sentinel Database Installation Prerequisites," on page
14 Continue with Completing the

3.7.4 Completing the Installation

After you have configured the database, perform the following steps to complete the installation.
1 If you chose to install the database component, configure the database partitions:
1a Select Enable automatic partition management to allow Sentinel Data Manager to handle
database partitioning and archiving.
1b For data partitions, specify an existing directory for archive files.
1c Specify start time for adding partitions and archiving data. These operations should not
overlap because they use shared resources.
1d Click Next.
1e Provide authentication information for the following:
Sentinel Database Administrator User

 Sentinel Application Database User
Sentinel Administrator User

Sentinel Report User (only on Windows)

NOTE: If the DAS component is also being installed, the Sentinel Application Database
User password is required even if Windows authentication is selected. This is required to
install the Sentinel Service to log in as the Sentinel Application Database User. No other
users require a password to be specified if you are using Windows authentication.
On a Windows Server 2008 platform with MS SQL Server 2008 database, the Sentinel
installation fails if you enter a weak password that does not meet Windows policy
requirements.
1f Click Next.
2 A summary of the specified Database parameters displays. Click Next.
3 If you chose to install any of the Sentinel Server components, specify the amount of memory
(RAM) to allocate to these components.
Installation.
33.
Installing Sentinel 6.1 SP2 51