Table of Contents
Advertisement
Assigning Switch Name and Location Information
Ezconfig will proceed to the next step in the setup:
Do you want to assign switch name and location information (Y/N/Q)?
System Name: Alpha1-1
System Location: Bld1
System Contact: James
There are changes detected, do you wish to save the changes permanently (Y/N)?
Note: The System Name, System Location and System Contact fields accept only alphanumeric
characters, characters like "#$..." are not supported. The maximum length of the value
cannot be longer than 31 bytes.
Saving the Configuration
After the name and location values are entered, Ezconfig will ask if you would like to have the changes be
saved into the Flash (permanently storage). Enter
There are changes detected, do you wish to save the changes permanently (Y/N)?
y
The configuration changes have been saved successfully.
Please enter 'show running-config' to see the final configuration.
Thanks for using EzConfig!
If during the session, the switch loses its power, the setup information will be lost if Ezconfig does not have
the chance to save the changes before power-down.
Using Ezconfig for Switch Setup
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
Y
to save the configuration.
2-3
Advertisement
Table of Contents
