Table of Contents
Advertisement
Enable routing for the switch:
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
The next sequence shows an example of configuring the IP addresses and subnet masks for the virtual router
ports.
(Netgear Switch) (Config)#interface vlan 10
(Netgear Switch) (Interface-vlan 10)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface-vlan 10)#exit
(Netgear Switch) (Config)#interface vlan 20
(Netgear Switch) (Interface-vlan 20)#ip address 192.150.4.1 255.255.255.0
(Netgear Switch) (Interface-vlan 20)#exit
(Netgear Switch) (Config)#exit
Web Interface: Setting Up VLAN Routing for the VLANs and the Switch
To use the Web interface to configure the managed switch, proceed as follows:
1.
From the main menu, select Routing > VLAN> VLAN Routing > VLAN Routing Configuration. A
screen similar to the following displays.
Figure 7-8
2.
Under the VLAN Routing Configuration, enter the following information.
•
Select 10 from the VLAN ID(1 to 4093) pull-down menu.
•
In the IP Address field, enter 192.150.3.1.
•
In the Subnet Mask filed, enter 255.255.255.0.
3.
Click Add to save the settings.
VLAN Routing
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
7-7
Advertisement
Table of Contents
