Configure Cos-Queue Min-Bandwidth And Strict Priority Scheduler Mode; Cli: Configuring Cos-Queue Min-Bandwidth And Strict Priority Scheduler Mode - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
5. The IP precedence to queue mapping of the interface is displayed.
Configure Cos-queue Min-bandwidth and Strict Priority
Scheduler Mode
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configuring Cos-queue Min-bandwidth and Strict Priority Scheduler
Mode
(Netgear Switch) (Config)#cos-queue min-bandwidth?
<bw-0>
(Netgear Switch) (Config)#cos-queue min-bandwidth 15
Incorrect input! Use 'cos-queue min-bandwidth <bw-0>..<bw-7>.
(Netgear Switch) (Config)#cos-queue min-bandwidth 15 25 10 5 5 20 10 10
(Netgear Switch) (Config)#cos-queue strict?
<queue-id>
(Netgear Switch) (Config)#cos-queue strict 1?
<cr>
<queue-id>
(Netgear Switch) (Config)#cos-queue strict 1
Web Interface: Configuring CoS-queue Min-bandwidth and Strict Priority
Scheduler Mode
To use the Web interface to configure CoS queue, proceed as follows:
1. Set min bandwidth 15 to the queue 0 of the interface 1/0/2.
13-6
Enter the minimum bandwidth percentage for Queue 0.
Enter a Queue Id from 0 to 7.
Press Enter to execute the command.
Enter an additional Queue Id from 0 to 7.
v1.0, November 2008
Class of Service (CoS) Queuing