Cli: Enabling Routing For Ports On The Switch; Web Interface: Enabling Routing For Ports On The Switch - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3

CLI: Enabling Routing for Ports on the Switch

(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#interface 1/0/5
(Netgear Switch) (Interface 1/0/5)#routing
(Netgear Switch) (Interface 1/0/5)#ip address 192.150.5.1 255.255.255.0
(Netgear Switch) (Interface 1/0/5)#exit
(Netgear Switch) (Config)#exit

Web Interface: Enabling Routing for Ports on the Switch

To use the Web interface to configure the managed switch, proceed as follows:
1. Assign IP address 192.150.2.1/24 to the interface 1/0/2.
a. From the main menu, select Routing > Advanced >IP Interface Configuration. A screen similar to
the following displays.
Figure 6-3
b. Under IP Interface Configuration, scroll down to interface 1/0/2 and select the checkbox for that
interface. 1/0/2 now appears in the Interface field at the top.
c. Under the IP Interface Configuration, enter the following information.
6-4
v1.0, November 2008
Port Routing