Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
•
Ports on the added unit should remain in the "detached" state.
•
A message should appear on the CLI indicating a code mismatch with the newly added unit.
•
To have the newly added unit to merge normally with the stack, code should be loaded to the newly
added unit from the master using the copy command. The newly added member should then be reset,
and should reboot normally and join the stack.
Web Interface: Upgrading Firmware
To use the Web interface to upgrade a stack member from a master, proceed as follows:
1.
From the main menu, select System > Management > Basic > Stack Configuration. A screen similar to
the following displays.
Figure 20-6
2.
Select the 2 from the Copy Master Firmware to Unit pull-down menu.
3.
Click Apply.
20-16
v1.0, November 2008
Managing Switch Stacks
Advertisement
Table of Contents
