Configure Cos-Queue Min-Bandwidth And Strict Priority Scheduler Mode169 - NETGEAR GSM7228PS Software Administration Manual
Managed switch release 8.0.3
Hide thumbs
Also See for GSM7228PS:
- Cli manual (788 pages) ,
- Datasheet (15 pages) ,
- User manual (628 pages)
Table of Contents
Advertisement
ProSafe 7000 Managed Switch Release 8.0.3
The IP precedence to queue mapping of the interface is displayed.
Configure Cos-queue Min-bandwidth and Strict Priority
Scheduler Mode
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure Cos-queue Min-bandwidth and Strict Priority
Scheduler Mode
(Netgear Switch) (Config)#cos-queue min-bandwidth?
<bw-0>
(Netgear Switch) (Config)#cos-queue min-bandwidth 15
Incorrect input! Use 'cos-queue min-bandwidth <bw-0>..<bw-7>.
(Netgear Switch) (Config)#cos-queue min-bandwidth 15 25 10 5 5 20 10 10
(Netgear Switch) (Config)#cos-queue strict?
<queue-id>
(Netgear Switch) (Config)#cos-queue strict 1?
<cr>
<queue-id>
(Netgear Switch) (Config)#cos-queue strict 1
Web Interface: Configure CoS-queue Min-bandwidth and
Strict Priority Scheduler Mode
1.
For Interface 1/0/2, set the minimum bandwidth to 15 for queue 0.
a. Select QoS > CoS > Advanced > Interface Queue Configuration. A screen similar
to the following displays.
b. In the Queue ID list, select 0.
Enter the minimum bandwidth percentage for Queue 0.
Enter a Queue Id from 0 to 7.
Press Enter to execute the command.
Enter an additional Queue Id from 0 to 7.
Chapter 11. CoS Queuing
| 169
Advertisement
Table of Contents
