McDATA StorageWorks 64 - SAN Director Switch Manual page 197

fcConnUnitPortControl
Syntax
Max-Access
Status
Description
INTEGER {
unknown (1),
invalid (2),
esetConnUnitPort (3),
ypassConnUnitPort (4),
nbypassConnUnitPort (5),
fflineConnUnitPort (6),
nlineConnUnitPort (7) }
read-write
current
This object is used to control the addressed fcConnUnit's port. Valid
commands are: unknown and invalid are only used as values that are
read.
resetConnUnitPort (3):
If the addressed connectivity unit allows this operation to be
performed on this port, the addressed port performs a
vendor-specific 'reset' operation. Examples of these operations are:
the Link Reset protocol, the Loop Initialization protocol, or a
resynchronization occurring between the transceiver in the
addressed port to the transceiver that the port is connected to.
bypassConnUnitPort (4):
If the addressed connectivity unit allows this operation to be
performed to this port, the addressed port performs a
vendor-specific 'bypass' operation. Examples of these operations are:
transitioning from online to offline, a request
(NON-PARTICIPATING) command to the Loop Port state machine,
or removal of the port from an arbitrated loop by a hub.
unbypassConnUnitPort (5):
If the addressed connectivity unit allows this operation to be
performed to this port, the addressed port performs a vendor-specific
'unbypass' operation.
Examples of these operations are: the Link Failure protocol, a request
(PARTICIPATING) command to the Loop Port state machine, or
addition of the port to an arbitrated loop by a hub.
Fibre Alliance MIB
A
FA MIB
A-31