Snmp-Server Contact; Snmp-Server Host; Snmp-Server Location; Username - Cisco CSACS-1121-K9 Reference Manual

Configuration Commands
Usage Guidelines Cisco recommends that you use underscores (_) or hyphens (-) between the terms within the word string.
If you use spaces between terms within the word string, you must enclose the string in quotation marks
(").
Examples Example 1
acs/admin(config)# snmp-server location Building_3/Room_214
acs/admin(config)#
Example 2
acs/admin(config)# snmp-server location "Building 3/Room 214"
acs/admin(config)#
Related Commands Command

snmp-server host

snmp-server community

snmp-server contact

username

To add a user who can access the CSACS-1121 using SSH, use the username command in Configuration
mode. If the user already exists, the password, the privilege level, or both change with this command. To
delete the user from the system, use the no form of this command.
For an existing user, use the following option:
Syntax Description
username
password password
hash | plain
role admin | user
disabled
email email-address
Defaults
The initial user during setup.
Command Modes
Configuration
CLI Reference Guide for the Cisco Secure Access Control System 5.1
A-140
username username password {hash | plain} password role {admin | user] [disabled [email
email-address]] [email email-address]
username username password role {admin | user} password
Only one word for the username argument. Blank spaces and quotation marks
(") are not allowed. Up to 31 alphanumeric characters.
Password character length up to 40 alphanumeric characters. You must
specify the password for all new users.
Type of password. Up to 34 alphanumeric characters.
Sets the privilege level for the user.
Disables the user according to the user's e-mail address.
The user's e-mail address. For example, user1@mydomain.com.
Description
Sends traps to a remote system.
Sets up the community access string to permit access to SNMP.
Configures the SNMP location MIB value on the system.
Appendix A ACS Command Reference
OL-18996-01