Password-Policy - Cisco CSACS-1121-K9 Reference Manual

Appendix A ACS Command Reference
To verify that ACS processes are running, use the
'show application status acs' command.
acs/admin(config)#
Related Commands Command
show ntp

password-policy

To enable or configure the passwords on the system, use the password-policy command in
Configuration mode. To disable this function, use the no form of this command.
The password-policy command requires a policy option (see Syntax Description).
Note
You must enter the password-expiration-enabled command before the other password-expiration
commands.
Syntax Description
Note
digit-required
disable-repeat-characters
disable-cisco-password
lower-case-required
min-password-length
no-previous-password
no-username
password-expiration-days
password-expiration-enabled Enables password expiration.
password-expiration-warning Number of days before expiration that warnings of impending
password-lock-enabled
OL-18996-01
password-policy option
After you enter the password-policy command, you enter the config-password-policy
configuration submode.
Description
Displays the status information about the NTP associations.
Requires a digit in the password.
Disables the password's ability to contain more than four identical
characters.
Disables the ability to use the word Cisco or any combination as the
password.
Requires a lowercase letter in the password.
Specifies a minimum number of characters for a valid password.
Integer length from 0 to 4,294,967,295.
Prevents users from reusing a part of their previous password.
Prohibits users from reusing their username as a part of a password.
Number of days until a password expires. Integer length from 0 to 80.
You must enter the password-expiration-enabled command
Note
before the other password-expiration commands.
expiration begin. Integer length from 0 to 4,294,967,295.
Locks a password after several failures.
CLI Reference Guide for the Cisco Secure Access Control System 5.1
Configuration Commands
A-133