Ip Address; Interface - Cisco CSACS-1121-K9 Reference Manual

Configuration Commands
Command Modes Configuration
Usage Guidelines You can use this command to configure subinterfaces to support various requirements.
Examples
acs/admin(config)# interface GigabitEthernet 0
acs/admin(config-GigabitEthernet)#
Related Commands Command
show interface

ip address

configuration mode)
shutdown
configuration mode)
ip address
To set the IP address and netmask for the Ethernet interface, use the ip address command in interface
Configuration mode. To remove an IP address or disable IP processing, use the no form of this command.
You can configure the same IP address on multiple interfaces. You might want to do this to limit the
Note
configuration steps required to switch from using one interface to another.
Syntax Description
ip-address
netmask
Defaults Enabled.
Command Modes
Interface configuration
Usage Guidelines
Requires exactly one address and one netmask; otherwise, an error occurs.
Examples
acs/admin(config)# interface GigabitEthernet 1
acs/admin(config-GigabitEthernet)# ip address 209.165.200.227 255.255.255.224
IP Address was modified.
ACS is restarting and a new HTTP certificate will be generated.
Stopping ACS ......................
CLI Reference Guide for the Cisco Secure Access Control System 5.1
A-124

(interface

(interface
ip address ip-address netmask
IPv4 version IP address.
Mask of the associated IP subnet.
Description
Displays information about the system interfaces.
Sets the IP address and netmask for the interface.
Shuts down the interface (see
Appendix A ACS Command Reference
shutdown, page A-137).
OL-18996-01