Application Reset-Config; Application Start - Cisco CSACS-1121-K9 Reference Manual

Appendix A ACS Command Reference
Related Commands Command
application install

application start

application stop
application upgrade
show application

application reset-config

To reset an application configuration to factory defaults, use the application reset-config command in
the EXEC mode.
Syntax Description application-name
Defaults No default behavior or values.
Command Modes
EXEC
Usage Guidelines You can use the application reset-config command to reset the ACS configuration to factory defaults
without reimaging the ACS appliance or VM.
Examples
acs/admin# application reset-config acs
Application successfully reset configuration
acs/admin#
Related Commands Command
acs reset-config
application start
To enable a specific application, use the application start command in the EXEC mode. To remove this
function, use the no form of this command.
OL-18996-01
application reset-config application-name
Name of the application to reset its configuration to factory defaults. Up to
255 alphanumeric characters.
application start application-name
Description
Installs an application bundle.
Starts or enables an application.
Stops or disables an application.
Upgrades an application bundle.
Shows application information for the installed application packages
on the system.
Description
Resets the ACS configuration to factory defaults.
CLI Reference Guide for the Cisco Secure Access Control System 5.1
EXEC Commands
A-25