Magnet Mounting - H3C LS-3100-16TP-EI-H3-A-O Installation Manual

Installation Manual
H3C S3100 Series Ethernet Switches
Figure 3-16 Wall mounting
4) Align the two installation holes at the bottom of the switch with these two screws to
hang the switch.
Caution:
When mounting the switch, keep the Ethernet ports of the switch facing downwards and
the two sides with ventilation holes vertical to the ground.

3.1.4 Magnet Mounting

The following two models support magnet mounting:
S3100-8TP-PWR-EI
S3100-16TP-PWR-EI
I. Introduction to magnetic mounting accessories
A set of magnetic mounting accessories consists of one permanent magnets and one
M3*6 countersunk head screws, as shown in Figure 3-17. Four sets of magnetic
mounting accessories are needed for each S3100 switch.
X mm
1.5 mm(Min)
3-13
Chapter 3 Installation