H3C LS-3100-16TP-EI-H3-A-O Installation Manual page 29

Installation Manual
H3C S3100 Series Ethernet Switches
(1): Power Led (PWR)
(3): D/S LED
(5): Port status LED, right (green)
(7): ONU module
(9): LINK LED for the uplink PON port
(11): 1000 Mbps uplink PON port
(13): MODE button
Figure 1-32 Front panel of the S3100-26C-EPON-EI
Note:
The S3100-26C-EPON-EI provides one expansion slot. You can order one more
ONU module (1000Base- PX20) as needed. For more information about ONU
modules, refer to section 1.7 "ONU Modules".
For details about the LEDs on the front panel, refer to section 1.4.1 "Front Panel
LEDs of the S3100-SI/S3100-TP-PWR-EI/S3100-C-EPON-EI Series".
II. Rear panel
(1) AC power socket
Figure 1-33 Rear panel of an S3100-26C-EPON-EI Ethernet switch
III. Power system
S3100-26C-EPON-EI Ethernet switches support AC input.
Rated voltage range: 100 VAC to 240 VAC, 50 Hz/60 Hz
Input voltage range: 90 VAC to 264 VAC, 47 Hz to 63 Hz
IV. Cooling system
The S3100-26C-EPON-EI has one fan for heat dissipation.
(2): A/L LED
(4): Port status LED, left (yellow)
(6): 10/100 Base-TX port
(8): Console port
(10): ACT LED for the uplink PON port
(12): Expansion slot
(2) Grounding screw
1-22
Chapter 1 Product Introduction