S3100-16Tp-Pwr-Ei - H3C LS-3100-16TP-EI-H3-A-O Installation Manual

Installation Manual
H3C S3100 Series Ethernet Switches
Note:
Only the recommended RPS can be used for S3100-26TP-PWR-EI Ethernet switches.
The –48 VDC in the equipment room cannot be used directly. Otherwise, the device
may be damaged.
IV. Cooling system
The S3100-26TP-PWR-EI has four fans for heat dissipation.

1.3.5 S3100-16TP-PWR-EI

I. Front panel
S3100-16TP-PWR-EI
10/100Base-TX Ethernet ports, two 10/100/1000Base-T Ethernet ports, two
100/1000Base SFP ports, and one console port. Each SFP port and the corresponding
10/100/1000Base-T Ethernet port form a Combo port. For each Combo port, either the
SFP port or the corresponding 10/100/1000Base-T Ethernet port can be used at a time.
Figure 1-27 shows the front panel of an S3100-16TP-PWR-EI Ethernet switch.
(1) Auto-sensing 10/100Base-TX Ethernet port status LED
(2) LINK LED for Combo port
(4) Power LED (PWR)
(6) D/S LED
(8) ACT LED for Combo port
Figure 1-27 Front panel of an S3100-16TP-PWR-EI Ethernet switch
Ethernet
(1)
1-18
switches each provide
(2) (3)
(8) (7)
(3) Console port
(5) A/L LED
(7) Mode button
Chapter 1 Product Introduction
sixteen auto-sensing
(4)
(6) (5)