S3100-16C-Epon-Ei - H3C LS-3100-16TP-EI-H3-A-O Installation Manual

Installation Manual
H3C S3100 Series Ethernet Switches

1.3.8 S3100-16C-EPON-EI

I. Front panel
The S3100-16C-EPON-EI provides 16 x 10/100Base-TX Ethernet ports, one 1000
Mbps uplink PON port, and one console port.
Figure 1-34 shows the front panel of the S3100-16C-EPON-EI.
(1): Power Led (PWR)
(3): D/S LED
(5): Port status LED, right (green)
(7): ONU module
(9): LINK LED for the uplink PON port
(11): 1000 Mbps uplink PON port
(13): MODE button
Figure 1-34 Front panel of the S3100-16C-EPON-EI
Note:
The S3100-16C-EPON-EI supports only one ONU module (required).
For details about the LEDs on the front panel, refer to section 1.4.1 "Front Panel
LEDs of the S3100-SI/S3100-TP-PWR-EI/S3100-C-EPON-EI Series".
II. Rear panel
(1) AC power socket
Figure 1-35 Rear panel of an S3100-16C-EPON-EI Ethernet switch
III. Power system
S3100-16C-EPON-EI Ethernet switches support AC input.
Rated voltage range: 100 VAC to 240 VAC, 50 Hz/60 Hz
Input voltage range: 90 VAC to 264 VAC, 47 Hz to 63 Hz
(2): A/L LED
(4): Port status LED, left (yellow)
(6): 10/100 Base-TX port
(8): Console port
(10): ACT LED for the uplink PON port
(12): Expansion slot (disabled)
(2) Grounding screw
1-23
Chapter 1 Product Introduction