Table of Contents
Advertisement
Installation Manual
H3C S3100 Series Ethernet Switches
Figure 3-14 Screw
(1) Outside edge of anchor kit
Figure 3-15 Anchor kit
II. Installation procedure
The wall-mounting procedure is as follows:
1)
As shown in Figure 3-16, drill two holes 5 mm across in the wall on the same
horizontal line, with a distance of X mm.
Note:
The distance X between holes varies with devices. For specific distances, see Table
3-4.
Drill two holes according to the sizes of anchor kits and screws so that anchor kits
could go into the holes, only the edges could remain outside the wall, and the
screws could be fixed on the wall tightly.
2)
Insert anchor kits into the holes and keep only the edges outside the wall.
3)
Drive screws into the anchor kits, keeping the inside of screw head at least 1.5 mm
(0.06 in.) away from the edge of the anchor kit so that the switch could hang on the
screws securely.
(1)
(1)
3-12
Chapter 3 Installation
Hide quick links:
Advertisement
Table of Contents
