H3C LS-3100-16TP-EI-H3-A-O Installation Manual page 61

Installation Manual
H3C S3100 Series Ethernet Switches
(1) Permanent magnet
Figure 3-17 Magnet and countersunk head screw
II. Installation procedure
Follow these steps to complete magnet mounting:
1) As shown in Figure 3-18, use a Phillips screwdriver to pass the countersunk head
screw through the round hole at the center of the permanent magnet, fasten it to a
blind nut in the dent of the switch bottom, and ensure that the permanent magnet
and the switch are fastened reliably.
Note:
Remove the cushion, if any, from the dent before installation.
To ensure the firmness of installation, be sure to use four permanent magnets to
secure each S3100 switch.
2) Attach the magnet-mounted device to the specified location. Take care not to get
your fingers stuck between because the magnetism is very huge.
(1) Blind nut in the dent of the switch bottom
(3) M3*6 countersunk head screw
Figure 3-18 Magnet mounting
(2)
(3) (2)
(1)
(2) M3*6 countersunk head screw
(1)
(2) Permanent magnet
3-14
Chapter 3 Installation