2
Installing the switch
CAUTION:
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open
the chassis, contact H3C for permission. Otherwise, H3C shall not be liable for any consequence
caused thereby.
Installation flowchart
Figure2-1 Installation flowchart
Start
Install the switch
Connect the power cords
Verify the installation
Turn on the circuit breakers
Operating correctly?
Connect interface cables
End
Installing the switch in a tank
Tank-mounting procedures at a glance
IMPORTANT:
• You can install the switch in a tank with a width of 21 inches or 23 inches. Before installation,
make sure the tank is applicable to the switch.
• The installation procedure in this document is only applicable to mounting the switch in an H3C
tank. To mount the switch in a third-party tank, see the document provided with the tank.
The switch comes with the mounting brackets, slide rails, and tank-mount adapters installed.
Troubleshoot
the switch
No
Turn off the
circuit breakers
Yes
2-2