H3C LS-3100-16TP-EI-H3-A-O Installation Manual page 87

Installation Manual
H3C S3100 Series Ethernet Switches
Figure 5-5 Sending file page
After the download completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Note:
You do not need to reset the HyperTerminal's bits per second and can skip the last step
if you have chosen 9600 bps. In this case, the system displays the prompt "BootROM is
updating now.....................................done!" instead of the prompt "Your baudrate
should be set to 9600 bps again! Press enter key when ready".
Step 9: Reset HyperTerminal's bits per second to 9600 bps (refer to Step 4 and 5). Then,
press any key as prompted. The system will display the following information when it
completes the loading.
Bootrom is updating now.....................................done!
III. Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
Chapter 5 Boot ROM and Host Software Loading
5-7