Table of Contents
Advertisement
Installation Manual
H3C S3100 Series Ethernet Switches
Step 6: Enter Y to start file downloading or N to return to the BootROM update menu. If
you enter Y, the system begins to download and update the program. Upon completion,
the system displays the following information:
Loading........................................done
Bootrom updating..........done!
III. Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):2
The subsequent steps are the same as those for loading the Boot ROM software,
except for that the system gives the prompt for host software loading instead of Boot
ROM loading.
5.3 Remote Software Loading
If your terminal is indirectly connected to the switch through Internet, you can telnet to
the switch, and use FTP or TFTP to load Boot ROM and host software remotely.
5.3.1 Remote Loading Using FTP
As shown in Figure 5-8, a PC is used as both configuration device and FTP server. You
can telnet to the switch, and then execute the FTP commands to download the host
program s3100-SI.bin and the Boot ROM program s3100-SI.btm from the remote FTP
server (with IP address 202.10.10.53) to the switch.
Figure 5-8 Remote loading using FTP
Step 1: Download the software to the switch using FTP commands.
<H3C> ftp 202.10.10.53
Trying ...
Press CTRL+K to abort
Connected.
Chapter 5 Boot ROM and Host Software Loading
5-11
Hide quick links:
Advertisement
Table of Contents
