Table of Contents
Advertisement
Installation Manual
H3C S3100 Series Ethernet Switches
Note:
Guide rails purchased from H3C apply only to standard cabinets 1,000 mm (39.4 in.)
deep. Use other supports to substitute for guide rails in the case of other cabinet
depths.
Installation procedure
Follow these steps to install a switch into a 19-inch standard cabinet:
2)
Wear an ESD-preventive wrist strap to check the grounding and stability of the
cabinet.
3)
Take out the screws packed together with the front mounting ears and fix one end
of the front mounting ears to the switch, as shown in Figure 3-3.
4)
Install guide rails on the brackets on both sides of the cabinet with M5 self-tapping
screws. Figure 3-11 is for reference only.
Figure 3-11 Install guide rails
5)
Hold the two sides of the switch and slide it gently along the guide rails into the
cabinet until it is located in a proper position, as shown in Figure 3-12. Ensure that
the bottom side of the guide rails and the switch are in close contact.
3-9
Chapter 3 Installation
Hide quick links:
Advertisement
Table of Contents
