1.14
Cutting Roll Media
The lead edge of the media should be cut when the media is loaded, on
recovery from a media jam, and when the lead edge of the roll is damaged.
There are two methods for cutting the lead edge of the roll media:
•
Automatic cut:
•
Manual cut:
This involves making selections on either the copier control
panel touch screen or the printer control panel.
Refer to the section " Setting up Media on the Copier Control Panel" in this chapter
and to "10.8 Automatic Cut Using the Printer Control Panel" in "Chapter 10
Additional Operations from the Printer Menu" for details about automatic cutting.
Open the media tray and slide the cutter manually.
Refer to section " Cutting Roll Media Manually" in this chapter.