Xerox 6030 User Manual page 217

TCP/IP
The following TCP/IP communication parameters must be set up.
Default Parser
Ethernet Setting
(Physical Layer)
IP Address
MASK Value
(Net mask)
E-Net Address
(Ethernet address)
FTP
Dynamic Routing
Static Routing*
The communication parameter nomenclature on the printer control panel will
sometimes differ from the nomenclature on Print Services on Web. The Print
Service on Web nomenclature appears in bold type in the table below.
Menu Item
Selects the parser or data format interpreter that will be
used when the input data format has not been specified
from among the available selections, that is, [ HPGL ],
[ VERSATEC ], [ TIFF ], [ CALS ], or [PS/PDF]. The
default setting is [HPGL].
Selects the ethernet setting/physical layer. The default
setting is [ AUTO ].
[ AUTO ]
[ 10BASE_T ]
[ 100BASE_T ]
The IP address of the machine in the format
XXX.XXX.XXX.XXX. The IP address can be
changed, if necessary.
The sub-net mask set up on the machine in the format
XXX.XXX.XXX.XXX. The subnet mask can be
changed, if necessary.
Displays the Ethernet address. The value displayed is
unique for the hardware and cannot be changed.
Determines whether or not to enable FTP. The default
setting is [Enable].
Determines if dynamic routing will be enabled. The
default setting is [ON].
Determines if static routing will be enabled. The
default setting is [OFF]. Set Static Routing to [ON]
when you need to view the device through a gateway
or router.
Description
Automatic recognition
Fixed at 10BASE_T
Fixed at 100BASE_T