Xerox 6030 User Manual page 433

Command name
Push/Pop Palette ESC * p # P
Start Raster Graphics ESC * r # a|A
End Raster Graphics ESC * r C
Transfer Raster Data ESC * b #
by Plane V[data]
Transfer Raster Data ESC * b #
by Row/Block W[data]
Set Compression ESC * b # m|M
Method
Source Raster Width ESC * r # s|S
Source Raster Height ESC * r # t|T
Move CAP ESC & a # h|H
Horizontal
(Decipoint)
Move CAP ESC * p # x|X
Horizontal
Move CAP Vertical ESC * p # y|Y
Y Offset ESC * b # y|Y
Destination Raster ESC * t # h|H
Width
Destination Raster ESC * t # v|V
Height
Command Command Meaning and function
Saves and restores palette information.
Sets the controller to the raster mode and
sets the start position and left margin of a
graphic image.
Indicates the end of raster graphic image
transfer.
Transfer's the data of a specified byte.
However, the CAP does not move to the
next raster position.
The plane pointer is updated but the row
pointer is not.
Transfer's the data of a specified byte as a
line or as a block by the current
compression method.
Determines the compression method.
Indicates the image width of succeeding
raster data.
Indicates the source raster image height of
succeeding raster data.
Moves the CAP horizontally by a specified
decipoint (1/720 inch).
Moves the CAP horizontally by a specified
value in Versatec resolution inch units.
Moves the CAP vertically by a specified
value in Versatec resolution inch units.
Moves the CAP vertically by specified
pixel rows.
Defines the raster output width for
succeeding Start Graphic command by
decipoint (1/720 inch).
Defines the raster output height for
succeeding Start Graphic command by
decipoint (1/720 inch).
Limit
Ignored
Data skipped