Xerox 6030 User Manual page 221

Centronics (optional)
The Centronics communication parameters are presented below.
Ack Mode
DMA Timeout
EOP Timeout
Job Separation
Menu Item
The Ack mode is selected from [ MODE0 ], [ MODE1 ],
[ MODE2 ], [ MODE3 ], and [ MODE7 ].
The default setting is [MODE0].
The timeout value for data input is entered within a range of 1 to
255 seconds. The default setting is [5 sec].
Determines if the EOP Timeout will be enabled [TIMEOUT] or
disabled [NO_TIMEOUT]. If set to [TIMEOUT], a Timeout
Value must be entered. The timeout value is entered within a
range of 0 to 99 seconds.
The default setting is [10 sec].
Sets the job separation. The default setting is [NO].
[ YES ]
[ NO ]
• If a value higher than [255] is entered for the DMA Timeout value, [255] will be set
as the value.
• Changes to the [Ack Mode] and [DMA Timeout] values will have no effect on
operations.
Description
Starts conversion processing once the command
that recognizes the end of the data is received,
even if this occurs midway through the file.
Performs the spooling process on the hard disk
until a timeout is issued.