Setting Up The Copy Features - Xerox 6030 User Manual

5.3

Setting up the Copy Features

The copy features (copying parameters) are defined in the table below. To set up the
copy features, press the <Custom Presets/Meter Check> key, select [Custom Presets],
and then select [Copy Features].
.
Switch Feature Buttons
Default Copy Features
Media Type for Auto Mode
R/E Preset
Variable Length Preset
Auto Image Rotation
Output Order Preset
Program Sort Preset
Setting Up the Other Copy
Presets
Copy Features
Lays out the menus and features on the touch panel.
Sets up the copying settings that the system returns to
when the <Clear All> key is pressed.
Specifies the default media type when copying in the
auto mode.
Defines the preset reduction and enlargement settings.
Sets up the default values for the variable lengths
specified for each media size.
When media that matches the portrait dimension of an
original is not available, this function will rotate the
image 90 degrees (from portrait to landscape) and print
it on media that matches the image's landscape
dimension. This feature requires that the width of at
least one media roll is the same as either the length or
the width of the original.
This setting is valid only when [Portrait] is
selected in Auto Mode.
Auto Image Rotation becomes invalid when
any of the following are set up for a job.
• Folder
• Lead/Trail Margin, Image Location,
Scan Start Position, Edge Erase
• Multi Job
Determines whether copies will be printed in ascending
order (first to last) or descending order (last to first)
when sorting is selected.
Sets up the sorting programs.
Sets up other copy presets.