Xerox 6030 User Manual page 278

Settings
The settings for this function are as follows.
Menu Item
Area Mode
Auto Layout
When [DISABLE] is selected for [Auto Layout], specify the desired offset value for the
media size to be used.
Menu Item
Media size
(fixed)
OFFSET X
OFFSET Y
For example, if the following settings have been made, an image with an A2 output size
will be printed with an offset of 20 mm in the X direction and 10 mm in the Y direction.
The plot area cannot be set up for TIFF and CALS data. Only the auto layout function
can be set for them.
Sets the range to be printed at [ ADAPTED ], [ FIXED ], [ IP ], [ IW ],
[ RASTER ], or [ FIRST ]. The default setting is [ADAPTED] . See
the next page for more details.
•[IP] and [IW] can be set for HP-GL data only.
•[RASTER] can only be set for HPGL data if the [PS
COMMAND] has been set to [Ignore].
•The PS command takes priority if [Ignore] has not been set.
Sets up the centering function. The default setting is [ENABLE] .
[ ENABLE ] Centers the image.
[DISABLE ] Does not center the image.
The media size for determining the position of the offset.
The media size displayed will differ in accordance with the
[Output Size] setting in [Media Series].
Sets the amount of offset to the right and left.
The offset value can be set within a range of –999 to 999 mm.
Sets the amount of offset up and down.
The offset value can be set within a range of –999 to 999 mm.
Refer to the section on "Media Series" for further details on paper groups.
OFFSET
Size
–
X ( 999 to 999)
A0 0 mm
A1 –10 mm
A2 20
mm
A3 0 mm
A4 0 mm
Description
Description
–
Y ( 999 to 999)
0 mm
10 mm
10
mm
0 mm
0 mm