Removing Powertrain Cradle Mounts; Coupling For Swing Arm Bearing; Replacing Bearing Sleeve, Right; Replacing Left/Right Bush - BMW C1 200 Repair Manual

Coupling for swing arm bearing

Replacing bearing sleeve, right

–

Removing powertrain cradle mounts

1
•
Remove bolt (3) for joint
•
Remove coupling (2) for swing arm bearing
•
Remove bearing sleeve (1) on right
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
The protrusion on the right is shorter than on the left
on the swing arm coupling (2)!
Watch the swing arm coupling (2) during installation!
X
Torque specification:
Coupling stud............................................... 73 Nm
46.52
2
3
C1460680

Replacing left/right bush

– Removing powertrain cradle mounts
1
•
Remove bolt (3) for joint
•
Remove swing-arm coupling (2)
•
Note bearing sleeve (1) on right
Additional operation: bush on right:
– Remove bearing sleeve on right (1)
00 8 574
•
Remove bearing sleeve (arrow) on left/right with
extractor, BMW No. 00 8 572, and internal ex-
tractor (21/3), BMW No. 00 8 574
2
3
C1460680
00 8 572
C1460690