Replacing Tdc Trigger; Reluctor Removal And Installation - BMW C1 200 Repair Manual

Replacing TDC trigger

12 11 060
•
Remove securing screws and remove ignition
trigger
When installing:
•
Make sure that cables are correctly routed
•
Cable clip must engage centring fixture (arrow) in
cover
•
Coat threads of self-tapping screws with Loctite
prior to installation (Tapite screws)
•
Note direction of installation for trigger
Fluids and lubricants:
Attachment bolt................................. LOCTITE 243
Adjustment specification:
Sensor gap ...........................................8 ± 0.4 mm
................................................. (0.315 ± 0.0157 in)
X
Torque specification:
Tapite bolts (+ Loctite 243) ............................ 6 Nm
12.8

Reluctor removal and installation

– Remove ignition trigger cover
– Turn crankshaft to TDC and lock in place with set
bolt, BMW No. 11 7 651
C1110200
....................................................See Group 11
a
L
Note:
When replacing the one-way clutch, release the at-
tachment bolts before removing the reluctor!
•
Remove screw
11 6 502
•
Use removal bolt, BMW No. 11 6 502, to press
off reluctor with one-way clutch
•
Check taper and keyway of reluctor
11 7 651
C1000220
C1110220