Replacing Telescopic Tube Cross Brace - BMW C1 200 Repair Manual

– Install seal holder ( 31.14)
a
– Install telescopic tube seal (
•
Install front wheel
– Install telescopic tube cross brace with telescop-
ic tubes ( 31.18)
a
X
Torque specification:
Clamp, telescopic tube ................................ 25 Nm

Replacing telescopic tube cross brace

– Remove telescopic tube cross brace with tele-
scopic tubes ( 31.11)
a
•
Remove front wheel
– Remove ball joint ( 31.18)
a
– Remove seals from both telescopic tubes
( 31.13)
a
– Remove telescopic tubes (
L
Note:
The remaining fork oil can be allowed to run out!
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Install telescopic tubes
1
5
X
4
3
•
Insert floating axle (5) through both telescopic
tubes while turning the floating axle (5) through
several rotations
L
31.13)
a
The threads (arrow) must be completely visible!
•
•
•
•
•
•
•
L
31.16) After tightening the floating axle (5) should still be
a
easy to turn and to remove!
–
–
•
–
X
Telescopic tube clamp ................................. 25 Nm
Adjustment specifications:
Adjustment dimension for upper floating axle to con-
tact surface of ball joint "x" ................268.9 ± 1 mm
............................................. (10.5866 ± 0.0394 in)
2
C1310360
Note:
Tighten clamps on (1, 4) floating axle
Adjust telescopic tubes to dimension "x"
Tighten clamp on (3) telescopic tube to specified
torque
Loosen clamp (1, 4) on floating axle
Turn floating axle while adjusting second tele-
scopic tube
Tighten clamp (3) on telescopic tube to specified
torque
Check installation by rotating floating axle (5)
Note:
Install seal holder ( 31.14)
a
Install telescopic tube seal (
Install front wheel
Install telescopic tube cross brace with telescop-
ic tubes ( 31.18)
a
Torque specification:
31.13)
a
31.17