Replacing Telescopic Tube - BMW C1 200 Repair Manual

Replacing telescopic tube

The following section describes the procedure for
the right telescopic tube. The operations for the left
telescopic tube are basically the same.
– Removing telescopic tube cross brace with tele-
scopic tubes ( 31.11)
a
•
Remove front wheel
– Remove telescopic tube seal (
•
Release telescopic tube clamp (arrows)
•
Drive out seal holder (1) in direction indicated by
arrow using support, BMW No. 31 5 711
•
Remove telescopic tube
L
Note:
The remaining fork oil can be allowed to run out
31.16
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
L
The following installation instructions apply exclu-
sively to replacement of one telescopic tube! If both
31.13) telescopic tubes are being replaced, refer to section
a
on telescopic tube cross brace replacement
( 31.17).
a
•
Install telescopic tube
1
C1310281
•
Insert floating axle (1) through both telescopic
31 5 711
tubes while adjusting new telescopic tube
L
The threads on the (2) floating axle must be com-
pletely visible!
•
Turn floating axle (1) through several rotations
•
Tighten clamp (arrows) for telescopic tube to
1
specified torque
•
Turn floating axle to check
C1310370
L
After the clamp screws are tightened the floating
axle (1) should still be easy to rotate and to remove!
Note:
2
Note:
Note:
C1310292