Assembling Driven Variator - BMW C1 200 Repair Manual

When installing:
•
Position grooved ball bearing (2) with open bear-
ing side toward needle bearing and use tube,
BMW No. 11 7 645, along with a hand press to
press it against its seat
•
Install the circlip (3)
•
Use hand press and assembly press,
BMW No. 11 7 642, to press in needle bearing (4)
•
Check inside diameter of outside plate and in-
spect guide groove for wear
Wear data:
Inside Ø..........................min. 34.05 mm (1.3406 in)

Assembling driven variator

•
Pack space between the two shaft oil sealing
rings with 4...5 g (0.14...0.18 oz) of grease
•
Grease O-rings and insert in grooves
11 7 645
C1110621
•
Use guide sleeve, BMW No. 11 7 644, to press
outer plate onto inner plate
•
Coat guide sleeves and guide pin with grease
and insert into 3 recesses in secondary outer
plate
11 7 642
L
Take care not to damage O-rings!
•
Slide on guide cover and position on stud in out-
side plate
Fluids and lubricants:
Shell Retinax HDX2 .............. 4...5 g (0.14...0.18 oz)
– Installing clutch (
C1110631
11 7 644
Note:
21.7)
a
C1110641
24.17