Check Mounts; (Inspection I); Final Inspection With Road Safety And Operation Check; (Inspections Ii, Iii And Iv) - BMW C1 200 Repair Manual

Check mounts

(Inspection I)

Check that bolts and nuts are securely tightened:
– Engine mounts
– Rear wheel
– Front wheel
e
Attention:
Never re-use the original nut on the rear wheel!
X
Torque specifications:
Floating axle, front ........................................ 30 Nm
Floating axle joint ......................................... 21 Nm
Tube link support bearing............................. 73 Nm
Engine mounts ............................................. 73 Nm
Rear lug nut
(use one time only) ..................................... 130 Nm
Final inspection with road safety
and operation check

(Inspections II, III and IV)

e
Attention:
Remove the vehicle stand, BMW No. 00 1 570.
•
Check wheels and tyres
•
Check tyre pressures and correct if necessary

Tyre tread depth (recommended minimum)

d
Warning:
Comply with legal requirements for minimum tread
depth!
Front wheel .................................... 2 mm/0.0787 in
Rear wheel ..................................... 3 mm/0.1181 in

Tyre pressures (tyres cold)

Solo
Front wheel ................................. 1.9 bar/27.58 psi
Rear wheel ................................. 2.1 bar/30.48 psi
With full load
Front wheel ................................. 1.9 bar/27.58 psi
Rear wheel .................................. 2.4 bar/34.83 psi

Roadworthiness check

•
Clutch
•
Steering
•
Brakes, front and rear
•
Condition of tyres and rims, tyre pressures
•
Lights and signalling equipment, indicator and
warning lights, instruments
•
Trial run if necessary
00.65