ZyXEL Communications ZYAIR G-4100 User Manual page 53

LABEL
WAN MAC Address
WAN Port Mode
DHCP Client
Static IP
IP Address
Subnet Mask
Gateway IP address
Primary/Secondary DNS
Server
PPPoE
Username
Password
PPP MTU Setting
TCP MSS Setting
Service Name
Connect on Demand
Keep Alive
PPTP
My IP Address
My Subnet Mask
Gateway IP address
PPTP Server IP Address
Username
Password
PPP MTU Setting
TCP MSS Setting
WAN, LAN and Server Setup
Table 4-1 WAN/LAN
Select Default to use the factory assigned MAC address.
If your ISP requires MAC address authentication, select Change to and enter the
MAC address of a computer on the LAN in the fields provided.
Select this option to set the ZyAIR to act as a DHCP client on the WAN. The ZyAIR
obtains TCP/IP information (IP address, DNS server information, etc.) from a DHCP
server. This is the default setting.
Select this option to set the ZyAIR to use a static (or fixed) IP address.
Enter the static IP address in dotted decimal notation.
Enter the subnet mask in dotted decimal notation.
Enter the IP address of the default gateway device. The gateway is a router or switch
on the same network segment as the ZyAIR. The gateway helps forward packets to
their destinations. Leave this field as 0.0.0.0 if you do not know it.
Enter the IP addresses of the primary and/or secondary DNS servers.
Select this option to activate PPPoE support. Refer to Section 4.6 for more
information.
Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components
exactly as given.
Enter the password associated with the user name above.
Enter the MTU (Maximum Transfer Unit) size.
Enter the MSS (Maximum Segment Size) size.
Enter the name of your PPPoE service.
Select this option when you don't want the connection up all the time and specify an
idle timeout in the Max Idle Time field. This is the default setting with an idle timeout
of 10 minutes.
Select this option when you want the Internet connection up all the time and specify a
redial period in the Redial Period field. When disconnected, the ZyAIR will attempt to
bring up the connection after the redial period.
Select this option to activate PPTP support. Refer to Section 4.7 for more information.
Enter the IP address assigned to you.
Enter the subnet mask assigned to you.
Enter the IP address of the gateway device.
Enter the IP address of your ISP's PPTP server.
Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components
exactly as given.
Enter the password associated with the user name above.
Enter the MTU (Maximum Transfer Unit) size.
Enter the MSS (Maximum Segment Size) size.
ZyAIR G-4100 User's Guide
DESCRIPTION
4-5