Service Type - ZyXEL Communications P-870HN-51B - V1.0 Manual

Chapter 5 WAN Setup

5.5.1.2 Service Type

If you set the DSL link type to PPPoA or IPoA for the ATM interface and configure
a WAN connection using the ATM interface, you only need to configure the Enter
Service Description field in this screen.
Figure 33 WAN Configuration: Service Type
Figure 34 The following table describes the labels in this screen.
Table 14 WAN Configuration: Service Type
LABEL
Select WAN
service type
Enter Service
Description
Rate Limit
Tag VLAN ID
for egress
packets
Enter 802.1P
Priority
76
DESCRIPTION
Select the method of encapsulation used by your ISP.
Choices are PPP over Ethernet (PPPoE), IP over Ethernet and
Bridging.
Specify a name for this connection or use the automatically generated
one.
Enter the maximum transmission rate in Kbps for traffic sent through the
WAN connection. Otherwise, leave this field blank to disable the rate
limit.
This field is not available for an ATM connection if QoS is disabled in the
DSL ATM Interface Configuration.
Select this option to add the VLAN tag (specified below) to the outgoing
traffic through this connection.
This field is available when the layer-2 interface is in VLANMUX mode.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into
a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through
this connection. The greater the number, the higher the priority level.
This field is available when the layer-2 interface is in VLANMUX mode.
P-870HN-51b User's Guide