ZyXEL Communications P-870HN-51B - V1.0 Manual page 190

Chapter 15 Quality of Service (QoS)
Table 66 QoS Class Configuration (continued)
LABEL
Ether Type
Source
MAC Address
MAC Mask
IP Address
IP Subnet
Mask
TCP/UDP Port
Range
Exclude
Destination
MAC Address
MAC Mask
IP Address
IP Subnet
Mask
TCP/UDP Port
Range
Exclude
Others
190
DESCRIPTION
Select a predefined application to configure a class for the matched
traffic.
If you select IP, you also need to configure source or destination MAC
address, IP address, DHCP options, DSCP value or the protocol type.
If you select 8021Q, you can configure an 802.1p priority level and
VLAN ID in the Others section.
Select the check box and enter the source MAC address of the packet.
Type the mask for the specified MAC address to determine which bits
a packet's MAC address should match.
Enter "f" for each bit of the specified source MAC address that the
traffic's MAC address should match. Enter "0" for the bit(s) of the
matched traffic's MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
Select the check box and enter the source IP address in dotted
decimal notation. A blank source IP address means any source IP
address.
Enter the source subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
Select this option to exclude the packets that match the specified
criteria from this classifier.
Select the check box and enter the destination MAC address of the
packet.
Type the mask for the specified MAC address to determine which bits
a packet's MAC address should match.
Enter "f" for each bit of the specified source MAC address that the
traffic's MAC address should match. Enter "0" for the bit(s) of the
matched traffic's MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
Select the check box and enter the destination IP address in dotted
decimal notation. A blank source IP address means any source IP
address.
Enter the destination subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
Select this option to exclude the packets that match the specified
criteria from this classifier.
P-870HN-51b User's Guide